Wednesday, April 23, 2014

Right Rear Quarter in Primer!

Quick on the heels of completing the bodywork on the right rear quarter, I wanted to get the right quarter safely coated in PPG epoxy primer so work could smoothly progress.  Recalling the complicating events of priming the left quarter, I was a bit hesitant to dive into the work as I was not sure what equipment issues I may encounter.

However, save for a few relatively minor glitches, the priming work consumed the better part of a Saturday afternoon anchored by near perfect weather.  Humidity was low and the temp in the high 60’s with almost no wind to stir up little nasties.  And after a thorough round of degreasing, I started the process by masking everything I didn’t intend to prime.  Learning a bit from the left side work, I was able to get good masking coverage with much less material than before without sacrificing any protection.  Bonus!
Another rinse with pre-prep solvent and about an hour of dry time had the surfaces ready for a cut-in and thin base coat of primer.  An hour of flash time, and a second coat was applied and allowed to dry overnight.  The end result was rather pleasing as everything was finally in a single, uniform color and the true contours of the panel were finally visible.  Fortunately, save for a few pinholes in a few spots of filler, the surface will block out perfectly after high-build primer application and we will be in business!  A few days to allow the primer to thoroughly harden will be in store as preparations begin to fit the lower valence, quarter extensions and the rear deck lid.  Once this work is complete, things will start getting interesting pretty quickly as the car starts looking more like it should! 

Right quarter in full primer is a nice sight to behold.  Arguably, this is one of the best angles of the 69-70 Mustang body form.
 
With clean fender lip lines and crisp body creases, this view begins to show how nice this quarter will look when fully finished.

A very subtle and often missed detail is the upper trunk opening corners.  The filled seam is clearly visible in this shot and I love the look!
 

Another look at the front trunk lid corner opening smoothed and primed.
 

And finally, a nice look at the roof seam area of the sail panel.  perfect flow with no hint there is any joint in this area.


6 comments:

  1. Wow. Just... wow. Nice work Sven.

    ReplyDelete
    Replies
    1. As always, you are too kind Alex. Hope the drop-top is getting warmed up for the season!

      Delete
  2. Well, I'm convinced. I will definitely be welding up the seams on the rear panel on my car. That is smooth and sexy!

    ReplyDelete
    Replies
    1. It's a bit tricky work, but now that I've seen it in primer, I absolutely love the look. Most people would never pick up the difference, but it really does clean things up.

      Delete
  3. It's got to feel good to see more and more of the Boss becoming one color in prep for paint. BTW, how much DP and catalyst did it take for the rear quarter panel?

    ReplyDelete
    Replies
    1. Even though it's primer, it is DEFINITELY a morale boost to see things come together in a single color.

      I used about 1/2 quart to cover the entire quarter, sail panel and window and trunk openings. Not a drop to spare when it was done.

      Delete